Recent content by Fedja

ok, I managed to get that piston out, tapped bigger hole for M8 bleeder. Now everythnig is nice and clean, but. Inside of cylinder there is some kind of eccentric groove that sticks out of the wall aprox half a milimeter. It goes half around the wall (hence eccentric). It looks factory but I...

thanx, will see that german site!

Anyone have link for those in europe?

Yeah, it gives odd chinese calipers with no dimension on mounting holes. It even requires some bracket to mount it. look; shorturl.at/iG246

Hi, This 1997 SR250 I have after few years of sitting in shed has baked in front brake piston and stripped bleed screw. I'm looking at affordable replacement but all I can find is NOS parts for couple of hundred dollars. Is there aftermarket part that will fit on that fork holes/disc?

Oi, I'm upgrading my SR with m.unit and I'm not sure what to do with brown wire from reg/rect. On stock it shorts to 12V when ignition is on. Should I use one of the aux outputs for it or use it as stock..splice it from ignition lock on side that goes to m.unit? Cheers Sent from my iPhone...

It's on Yamaha SR250. Size is 34 mm.

Hi, is it possible to replace CV carb for flat slide kind? Is it good or bad idea? Will motor take it?

What year is that SR? I have one from 1997, will snap a pix tomorrow. cheers!

It is adjusted that way. Anyway I screwed idle mixture one turn in, adjusted idle screw a bit to get it on 1300 rpm and voila, no more stalling.

omg I got emotional on this one...sitting on job..and wining like a girl.

Here is my SR250.

b e a utiful! well done job!!!

Hi Bert, There is no de-compression thingie on SR250. It's a bit rich in idle? Hmm gonna try with smaller pilot and see if it happens. cheers

I need some help finding fault. It is SR250 with open exhaust and pod filter. Pod filter is fitted onto old air hose to eliminate turbulence. Carb is rejeted, plug is dark brownish. Throttle response is ok trough all ranges. Bike starts with a blip of throttle. It idles at 1300-1500 when fully...