Recent content by ken hosford

and where might you and the bike reside?

I could sell you a Brit one but fittings would be wrong and would not fit your frame well . You could start by mocking one up in cardboard . you will need to figure out were and what to use for filler feed, return lines and vents With proper mock up I could fab one out aluminum , steel, or...

am not into upholstery but can make a steel or stainless or aluminum base similar to pictured pm me your email address and can send pictures

looks more Benneli to me

20 gage is thicker than most factory seats but... they have shapes that give them strength it is all in those lips ,ridges ,etc , flat 20 gage is way flexible

If you can not put curve in16 ga you are not using your imagination the picnic table top at the park just need a little prying with your flat seat pan, A lot of gentle bends try it, it will work.

I believe you can get the red fiber washers at A good hardware store , auto parts stores often have assortment packs

I have nos. Akront flanged/ridged drilled for 750 Honda $125

I can make you stainless fender to any width or dia. If interested I can get you pictures

If other offer falls though I have a nice set taken from low mile wreck back in late 70s Ken

I have a brand new Akront alloy ridged rim drilled for cb 750 some shop wear $125 Ken

looks small yamaha enduro

Looks British aftermarket definitely British cap

70s large hub spoked

Not a wheel But have NOS Akront ridged drilled for cb750 Ken