Recent content by nixon

appreciate the feedback guys! Ive got some red kote so will go that way..

Hi hoping for some input please..i got a tank via cycle -x..who had a few tanks from a potential supplier. a note taped to the bottom advises 'seal before use'. Is this needed with raw alu? redkote etc? thanks!

love it. tough

hey good score on the xl500 ive got a 79 xl250 same frame i gather. 23" front wheel? If you want to get similar to your inspiration pics..maybe check how I added some rails to lift and flatten the seat? solves getting the height I need ( im 6.1) ..without a super thick stock seat.

nice stock bike! ebay it for sure. Guys buy bikes from all around the world. the fees you pay are out weighed by the higher price you get. Assuming you'd take 2500 now.. just put it starting price $2800 No reserve , if cash. State in ad buyer to pay paypal fees ( or they can 'give' you the...

nice work...good idea. there is 100 ways to skin a ..rabbit. ( why do cats get skinned??) nice bike.. do you have plans changing the seat on it?IMHO reckon it would look mean with the tank ( seat end) raised slightly and a flatter seat

well found some time and beat the top 1/3 of tunnel both sides..great, fits fine. but i totally missed the bottom section ..the frame has a support on the k7 the k4 didnt have. will need to cut/weld the bottom 1/3 will talk to some local welders tomorrow. kinda bumped this for others to...

the cb750A has small 26mm carbs stock, and milder cam than K or F

from what ive read - heavy duty would be overkill unless your 2 up and loaded with gear- constantly no idea about about comparison of 14 vs 12 series

Yeah that would work for sure. I've seen a really dark metallic green on .land rover also would work well. This has been on the back burner while I sort out the 77 cb750a I got . Debating selling the xl and leaving tank colour to buyer

...Thanks guys, exactly what i wanted to hear.. .yeah i definately dont have the skills for a tank weld job... I was surprised it was suggested.. Will take before / after pics..

Ok cool- i can use the old tank as a template. what type of welding will work? gas- brazing, tig? Ive got an inverter arc which woudnt work on that thin steel i think

After searching quite a lot, there's mention of widening tunnels on various bikes..and technique seems to be cold hammering. Thought id put it out their in general- Whats your opinion on this? how far can you go safely? whats the risks- can it impact on outside shape? I gather it can with a...

rear is 18. Think it was about 250 for both, spokes and nipples. They came with a special lube which is vital