Recent content by Rockthehellout

  1. R

    1976 750K: Need Rear Brake Arm + Rod

    Need the rear arm from the wheel hub to the rod, as well as the rod. Also looking for the front (right) oil supply line if it's not leaking. Located in Las Vegas...have a good amount of stock parts to swap as well if anyone is looking for a trade.
  2. R

    CB750k Oil Line Mystery

    Pulled the engine, rebuilt the top end, and reinstalled in about 3 weeks time. The first couple of test hits were great, not a leak in site, good compression and oil pressure. Hit the freeway and I have a small, but substantial, leak coming out of the crimped portion of one of the oil lines near...
  3. R

    Stumped, help! 4.5" spacer on top of spring

    When I laid down last night I started mulling it over and yeah, longer fork tubes seemed to be the only logical explanation. On my way out, while already 5 minutes late, I threw a measuring tape on it and it shows 23.5" from top to the slider (with no cap on top of the tube) fully extended. OEM...
  4. R

    Stumped, help! 4.5" spacer on top of spring

    When mocking up the stance of my 76 cb750, I have the fork tubes slid 3.5 inches up the trees. The PO wanted this thing to be a cruiser, including the old header mounted cruiser foot rests...awesome. Tonight I popped the caps off the forks, and WHAM...nothing happened. I look down to find a...
  5. R

    No power to solenoid cb750k / slow crank

    PO never had the electric start working, so I'm trying to get this resolved. I was able to jump the solenoid and get it fired up and running about three times, however the starter has since slowed to a crawl when I try this. New solenoid installed, new condensers, battery and plugs. Points are...
  6. R

    CycleX Exhaust Fitment Issue

    Long time lurker, first time poster, apologies if this is in the incorrect location for some reason. I recently purchased the super sidewinder from cyclex for my 76 CB750 build. With the header in as far as it will possibly go, the flanges on the pipes are 3/4" away from the heads (and this is...
  7. R

    CycleX Exhaust Fitment Issue

    Long time lurker, first time poster. I recently purchased the super sidewinder from cyclex for my 76 CB750 build. With the header in as far as it will possibly go, the flanges on the pipes are 3/4" away from the heads (and this is without crush gaskets in there). The guys over at cyclex swear...
Back
Top Bottom