Search results

I'm looking to get the cylinder of my TS250 Suzuki bored out 1 over. How much would a machine shop charge to do that kind of work?

I'm getting a little stumped on this one guys. I'm hoping someone here can give me a little guidance. I've been doing an full electronic upgrade to the '72 cl350. I put on a Pamco Ignition, Dyna Coils, new rectifier, new stator, new spark plugs, and new spark plug wires. I have all of them...

I have a cb350F that is so close to being finished. The bike looks great and runs pretty good on the road after a lot of carb tuning. The issue I'm having now is an electrical one. I put in a smaller battery, a 5Ah. Now the battery won't hold a charge at all. The longer I run the bike, the...

Alright, I have been working on my cb350f for about a year now. It's seriously close to being road ready. Today I've been working on getting the carbs synced. I'm able to get all four around 10 psi. The problem is that it's not idling well at all. It still sounds sick. Anytime I hit the...

Alright, I'm having issues with my brake light and running light. The brake light will work when I engage it when I put the key ignition into the on position, but the running light won't turn on. Then when I put the ignition into the accessory position, I can get the running lights to turn on...

I recently bought some LED turn signals at Cycle Gear. After installing them, when I use the right turn signal both of the signals turn on in the back. When I hit the left signal, only the left turns on. What is causing that problem and how do I fix it? The other issue at hand is that none...

So I'm not getting any spark on my bike and I'm starting to get a little stumped. I replaced the battery and charged it on a trickle charge like it says. I replaced the spark plugs and the spark plug caps. The wires to the spark plug look good so I didn't mess with them besides cutting about...

Alright, you guys have already helped a lot on my project. Now I'm trying to figure out how to attach the throttle linkage. It's like its half an inch too short. Am I doing something wrong or do I need longer cables? Thanks again for all the help. I should just get around to doing a build...

Alright, I have my carbs ready to be reinstalled onto the bike. The problem is, the fuel lines were never attached to the tank when I bought the bike so I'm not sure how they go. I know the four lines on the float bowls are spill over lines. The question is, where do the other three lines go...

Hi guys, I'm new here. This is also the first bike I've ever owned so any work I'm doing on the bike is very new to me. I'm getting a little stuck right now and I'm hoping you guys can help me out. Last week I bought a cb350f. The carbs on there seem pretty good except that on one of the...