Search results

Yes what he said... Location?

Need intake valves, pistons and 4 rockers for a CB 350f If you have a complete engine either 350f or 400f I wouldn't mind knowing the cost I'm dead in the water and would like to be back on the street soon

Tried to go out and fill the tank this evening to no avail. She fired off as usual but since I didnt have the throttle set so she died from being cold (nothing unusual there) Went back to crank again and I swear I heard something break inside. Sounded like aluminum breaking in half. Motor...

Can you post a sample first just so I can be assured it is pleasing to the old eyes ;) Have you ever printed seat stencils?

Re: Gauge Faces / Speedo Tach Decals This in black. Solid white #'s. Make the red hash @ 70mph white like the others. Change the red 350 to the closest 350f orange you can get. Finally color the hash marks at and past redline orange. I would like to see what that would look like. How well...

When will you be ready for another design change? I have something in mind for the 350f

http://www.ebay.com/itm/Universal-Flexible-32-LED-Motorcycle-ATV-Tail-Brake-Stop-Turn-Signal-Strip-Light-/301781120866?hash=item46438e7762:g:rQcAAOSwT5tWHcj0&vxp=mtr...

I'm in cute muffler ;)

Gas tank, Wheels, front fender - condition/price?

I plan to cut my front like I bobbed my rear. Use tape to make a straight line to cut the first 2" off then tape off the part I want to remove and cut that out. Weld the end you cut off to the fender grind, fill and paint DONE fWIW the metal is THIN so I use spot welds to keep from warping it...

I removed the head on my 350f to fix the leak with new gaskets and found that two of the studs have worked their way loose. Is it advisable to pull these and add some thread lock or just tighten them back up without it.

I still have it yes I think a few of the rubber grommets are gone that go between the carbs and box. I can check Friday for you. How much of it do you need.

Thanks for thinking of me better luck next time. You have my # if you find anything worthwhile. You were right about eBay gees 80 for just 1 peg. No thank you

72 350F 4-1 kERKER

That's what I am looking for. Been watching eBay and you are right they are ridiculously priced. You say the 77's are not right for the 350. Which years work?

Looking for a set of factory pegs and controls

Lucky you didnt go out in a BLAZE of glory

6" over stock length 35mm fork tubes from a cb500

Yes just the upper tubes I have a front end from a 500 that are 6" over stock length and am looking for a stock length of either 500 or 550 to put with the lowers and trees on my 350f

Interested in the upper fork tubes if they are available.