Search results

Hi, I am ready to start my bike up after doing a partial rebuild on the motor this winter and want to make sure I have everything ready to go. It had a blown head gasket and weak compression so I had the cylinders honed and got new rings. The top end looked fine with no pitting on the rockers...

I'm rebuilding my CB360 and would like to toss the stock wiring harness to simplify everything. I bought this kill switch from DCC and it looks like its a "push to close" type kill switch. So the circuit is closed only when I push the button, otherwise it springs open and breaks the circuit...

Maybe I'm overthinking this, but I feel like the service manual might be leaving something out. I'm rebuilding my CB360 motor and it says to put the generator at "LT" and then line up the cam sprocket with the head and put the timing chain on. It doesn't say anything about cam lobe...

Hey guys, Seems like a fairly common question, but I had a tough time finding any answer. I'll be painting my CB360 frame in my garage and was told that Eastwood Chassis Black is a good paint to use. Since I can only find it online I'd like to avoid multiple orders and just get everything at...

I'm prepping my cb360 frame for paint and noticed a dent along the bottom of the frame evenly on both sides. No cracks but there is a small dent in each tube and the paint chipped so a lil surface rust. I got a lil carried away with my flapper wheel while removing the rust and flattened out...

Hey Guys, Quick question about spray painting in the winter. It's getting colder here and my garage is now in the 30-40 degrees range. I want to paint my motor while I'm rebuilding it and have it all taken apart. If I keep the engine parts inside along with the paint cans before painting...