Search results

Re: "La Pastinaca" CB450 498cc Big Bore Engine! Before and after photos! Hey boss! Did the Mikunis/Velocity stacks fit under the side covers on the bike? My carburetors are dead...I will be converting to VM32's by the end of the week.

Re: "La Pastinaca" CB450 498cc Big Bore Engine! Before and after photos! Beautiful build! Where did you get the manifolds to run Mikunis? I think the hole to hole spacing on the intake manifolds for the CB450 was an odd size (64-65mm)..

Re: 71 CB350 Project (SHE'S ALIVE!!!!) Hey. Nice build. What size pilots are you running, and what needle setting are you on? My VM's I am running a 130 mains, with 22.5 pilots, and needle in the middle position. It feels great from 5.5upward, but slightly hesitant under 5.5K.

Hello, I have a 1971 CB350 I noticed my bike revs out at 9200 RPM, while my buddies revs out at 10500RPM. Do the engine have different camshafts? Just wondering if the bikes have different internal parts. If they do, are they compatible? Thanks Marco

I have vm30s, they are jetted for 2-2 free flowing pipes.

Hey guys. I think I would like to go that route. Could you post your picture please? Also wheres a good place to get a collector and nice muffler? I am not sure a standard Dunstall style pipe will flow both pipes. I really dig the muffler on the "poquito mas" bike. Thanks Marco

This is my bike.

Hey guys, I just bought my rear sets from Motobits and I am overall pretty happy (except for the threaded rod for the rear brake, it flexes like crazy). I currently have a 2-2 exhaust with small canisters. The rear-sets pose a problem with my height though, I am 6-3. So to be comfortable and...

If I were to but them from a different vendor would you gentlemen be so kind to help me jet the carburetors properly? -Marco

Thanks. What do you think of this kit? http://cgi.ebay.com/ebaymotors/Honda-CB350-CL350-Mikuni-VM30-Carburetor-Set-350-CB-CL-_W0QQcmdZViewItemQQhashZitem35ad990564QQitemZ230545753444QQptZMotorcyclesQ5fPartsQ5fAccessories Or would it be better to source it out?

Hey guys. My carburetors are giving me problems. The bike runs pretty well, but after some tuning and investigating I discovered the carburetors are not same left to right. The fuel adjustment screw is different(the whole casting). Has anyone upgraded to flat slides or round slides? Did you pull...

Well it happened a while ago. I got the bike running (cleaned carburetors, set timing, adjusted valves). It would start pretty much first kick. The forks were leaking so I decided to rebuild them. It took me about two weeks to get around to it (didn't start bike for about 2 weeks). I tried to...

Hey guys. My name is Marco. I live in Los Angeles. i just bought a Yamaha SR250, plan on building a little cafe out of it. Probably going to use a RD400 tank I found in my garage with a cafe style seat from eBay. Wheres the best place to order Yamaha parts(gaskets, seals, pistons). Maybe...