Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I have a 1974 Honda CB 550 K. that I had bought this spring in hopes of making a café bike out of well my game plan has changed and I have decided to work on restoring my OSSA 250 Pioneer instead
I’m thinking the best thing to do is sell my Honda I'm trying to figure out what it's worth?
It...
the brake side axle holder or what I call end cap will not pop apart so I can't separate the front wheel from the fork
is there a trick to this or do I have to get a hammer and chisel and beat it apart ??
Ok after looking at the front wheel of my cb550k I am seriously considering putting dual disk brakes on it everything is there but the rotor, caliper, caliper arm and a bigger master cylinder.. to me it looks like they were going to do it at the factory but didin't ..
I've always heard...
Ok I bit the bullet and bought a 1977 cb550k now I'm taering It apart
the rear wheel brake is frozen and I can't get it apart to work on it the Clymer Manual is not telling me much on what to do any one have sum wisdom to share on this ..
Thanks
Deuce
Hi all :
If you had your choice of a Honda 1974 cl360 a 1977 cb550 or a cb500 made some time in the 1970s witch would you choose and why
they are all in about the same condition " not running low compression engine turn freely "
I want to turn one into a Cafe racer ..
Ok I got the engine out drained the oilremoved the starter boath the side covers and the plugs but when I crank on the kickstart it turns freely for about one and a half turns and then it gets really hard like a compression stroke but there's no plugs so what is going on ??
Thanks
Deuce
any one know what tanks will work with my 1974 cl360
I like the Benelli Ducati NOS 360 Mojave but will it fit ?? are there any others might work
thanks
Deuce
My cl360 has front drums is there any way to change them to disk I know sum of the cb360 had disk what should I Be looking for at the swap meets ??
thanks
Deuce
why do all the cb550 I finde have bad compression and by bad I mean the last four I have seen are between 75 85 psi is it just a bad engine did people just run them into the ground is it that it was ran on unleaded gas or what ??
my 1977 cb550k is at 75psi in three cylinders ..
Ok I said I was NOT going to do this and now I'm thinking I may ..
how hard is it to put a monoshock on a bike I've got a CB550k and a CL360
I have all the equipment and I'm a experienced fabricator with Jeep's, boat's and snowmobiles but not with motorcycles so how hard is it and is
The guy I got my CL360 from lost the key now I'm trying to figure out how to bypass it so I can start it and what I should do for a nwe Ignition Switch and Key ??
thanks
Deuce
I just got my hands on a 1974 Honda CL360 I'm thinking of doing sum porting, milling and boring but have never dun this to a 4-stroke Honda before..
can you port the engine and keep the stock Constant Flow carbs and how much room do you have to bore and mill ..
I'm 6'5" and 225 lb's and I'm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.