Literally, every wire on the front end of my project 350 was twisted and wrapped with electrical tape. I've rewired the rear of the bike, so i'm tackling the front today and have a few questions because some of the wires on my diagram are hard to make out. I had to pull apart the switches and rebuild everything inside, and didn't notice all of this until I removed all the electrical tape.
Coming out of the headlight dimmer, there is:
*Solid yellow -PO had it wired to headlight - whereas my diagram shows it wired to yellow harness wire which connects to reg/rect/alt.
*White - PO had it wired to white wire (yellow connector) coming out of main harness. My diagram shows this solid white connecting to headlight.
*White/yellow trace - PO had it wired to solid yellow wire out of harness. I believe it goes to white harness wire (which i'm assuming is the white/yellow trace that goes to the alt. since the connector itself has a yellow shield - and my diagram shows a little yellow box).
Am I correct with the above thoughts?
Yellow to main yellow harness wire
White to headlight
White/yellow trace to white main harness wire (plastic shielding is painted yellow - appears to be factory)
Coming out of the headlight dimmer, there is:
*Solid yellow -PO had it wired to headlight - whereas my diagram shows it wired to yellow harness wire which connects to reg/rect/alt.
*White - PO had it wired to white wire (yellow connector) coming out of main harness. My diagram shows this solid white connecting to headlight.
*White/yellow trace - PO had it wired to solid yellow wire out of harness. I believe it goes to white harness wire (which i'm assuming is the white/yellow trace that goes to the alt. since the connector itself has a yellow shield - and my diagram shows a little yellow box).
Am I correct with the above thoughts?
Yellow to main yellow harness wire
White to headlight
White/yellow trace to white main harness wire (plastic shielding is painted yellow - appears to be factory)