Hey Guys,
I've always gotten amazing tips and advice on here, just want to preface this with: These are probably really dumb questions for most of you. I am almost finished with my first ever complete tear down project on this 1974 CL360. Labeled a ton of parts but you know there's always random ones that get through. So i'll put them all in one thread for you guys. Any help is appreciated. (side note, most of these I can't find solutions in my clymer)
1- Reinstalled the carbs. I have this guy just dangling. The metal tab looks like it should be fixed to something. Can someone tell me what this is and where it goes?
2- I've adjusted throttle push/pull cables on my harley. I'm having a tough time getting this CL360 to snap back quickly. it's not super slow however it's slow enough to want to fix. On my harley both the push and pull cables have adjusters however these cables don't (chrome one does and black one doesn't). do i adjust at the carb level as well? Any step by step would be great. didn't see anything in my Clymer Manual.
3- Need new gaskets for the exhaust. I believe this is correct, copper ring that goes into the engine? Can someone confirm. It does fit right in and rests on the little flange inside the engine (no way it could fall in, impossible)
4- Can't seem to figure out where the spring on my foot pegs go?
5- Hooking up the gas lines, Just want to confirm i have this right. The tube (now painted white) on the bottom of the tank, is that just a simple crossover to the other side? Then it's just 2 tube from the bottom of the petcock each going to the bottom of the two carb bowls correct? Just want to make sure. Another dumb question: if i put in fuel filters where do they go? (i bought 1 but looking at it i feel like i actually need two)
I've always gotten amazing tips and advice on here, just want to preface this with: These are probably really dumb questions for most of you. I am almost finished with my first ever complete tear down project on this 1974 CL360. Labeled a ton of parts but you know there's always random ones that get through. So i'll put them all in one thread for you guys. Any help is appreciated. (side note, most of these I can't find solutions in my clymer)
1- Reinstalled the carbs. I have this guy just dangling. The metal tab looks like it should be fixed to something. Can someone tell me what this is and where it goes?
2- I've adjusted throttle push/pull cables on my harley. I'm having a tough time getting this CL360 to snap back quickly. it's not super slow however it's slow enough to want to fix. On my harley both the push and pull cables have adjusters however these cables don't (chrome one does and black one doesn't). do i adjust at the carb level as well? Any step by step would be great. didn't see anything in my Clymer Manual.
3- Need new gaskets for the exhaust. I believe this is correct, copper ring that goes into the engine? Can someone confirm. It does fit right in and rests on the little flange inside the engine (no way it could fall in, impossible)
4- Can't seem to figure out where the spring on my foot pegs go?
5- Hooking up the gas lines, Just want to confirm i have this right. The tube (now painted white) on the bottom of the tank, is that just a simple crossover to the other side? Then it's just 2 tube from the bottom of the petcock each going to the bottom of the two carb bowls correct? Just want to make sure. Another dumb question: if i put in fuel filters where do they go? (i bought 1 but looking at it i feel like i actually need two)