joe_russo31
Been Around the Block
So I've removed the support rod, rear brake adjuster nut and the cotter pin and axle nut, and jacked up the rear so the tire's just off the ground, but now what? The Clymer manual just says 'remove the axle' or 'pull out the axle' or something like that, but it doesn't seem quite that simple.
Is there a trick? Use a puller? Anything?
Thanks in advance for any advice you all can give me!
Joe
Is there a trick? Use a puller? Anything?
Thanks in advance for any advice you all can give me!
Joe