JRK5892 said:nice man! looks like you have a plan... get better and get rolling! i may have an extra set of rear set GSXR pegs for you if you want em.. they are pretty banged up but may work for you
boomshakalaka said:ya, next time its closer to 30° Im going to go out to the garage and see what I can find to tinker with.
As for the sandblasting, Im actually going to leave all the parts just blasted except the case which isnt getting blasted but paint instead. I like the matte look of blasted metal. Who knows though, I may change my mind, Ive done it several times already
JRK5892 said:man you can not do that, yoiu are going to have to clear them or protect that metal in some way, blasting will open up the metals poors... if you do not then put a protective layer it will carode like you have never seen... in the right humidity OVER NIGHT even... can be bad news.... you can still keep the mat rough looked just use a satin clear after blasting
JRK5892 said:problem with high temp clear, is that it spiderwebs, as well as will have a gloss finish... personally I think the gloss finish over the raw metal would look cool... but i am not sure how well it would hold up. nice part about it is it is cheap...so if it does not hold up well just add another coat!
jason teamshralp said:looks good man, I'm about where you are on my rebuild.
http://www.hondatwins.net/forum/viewtopic.php?f=17&t=518&start=0&st=0&sk=t&sd=a
I've found a ton of rubber and metal bit's in my engine, I only have one motor, I wish I had three. I was wondering where you got your cam tensioner from, I've looked but can't find any.
Also are you going to go into the bottom of the case to look for the rest of the metal?
keep it up.
Wee Todd said:I had a close look at your cam,it's a high lift, longer duration(early style) and the cam sprocket and rockers are specific to that cam..$$$$$$$$ very hard to find! sell? and salvage a late cam from another motor,,,,,,,,whats it worth ...$100 cam, cha ching with the rockers and sprocket, down side high wear(supposedly) on cam and rockers, big difference in top end!!!!!!!!!