I have about 250 miles on mine (Pamco E-Advance). Would of had more, but broke my foot shortly after installing it, was off the bike most of last year....Had some other health issues too.
The install was as easy as putting points on, but finding a good mounting point was difficult. Not totally happy, and I think if I leave it where I have it (Bottom outside of battery box) I need a small drain, just in case liquid gets in. I will revisit that after I get more miles on the system.
The timing REQUIRES a strobe type timing light. The adjustment is a little fiddly (so are points) but the great part is you only have to do it once.
The unit works great as an ignition system. When warm, it seems to start the bike in a revolution, very quickly. The bike idles well and smooth. I am stock airbox and carburetor and aftermarket, but stock length exhaust. No lean conditions. The bike pulls hard and smooth to the top of the RPM....I've only done it a couple of times, but you need to be careful as it will cross the redline. No point float.
The driveability is excellent. No hiccups from ignition. It advances as it states, by around 3000 RPM ful advance. Strange, hHonda did it that way, but in normal riding, the engine is rarely below 3000 RPM except at stops and lights.
I am pleased as today (April 19th, 2015) I rolled the bike out of my garage after sitting untouched since October. I can tell you from experience that even well adjusted and clean points will often need cleaning after sitting for 7 months. Alweays a little cleaning and adjustment, and the accumulated wear from the previous year. I prepped the bike (oil - changed)checked tire pressure, looked for loose items. Then as I normally do, I kicked it over, ignition off, 3 or 4 times to circulate a little oil.....I then bump the e-start and get a little more oil around.... Then, fuel on, full choke, 2 kicks, ignition off....Then 1/2 choke, no throttle, ignition on (This procedure is for when the bike has been dormant for more than a week or 2). It either starts immediately, or coughs....She coughed once, second kick was running like I put it away in October.
After warming a minute, at low idle, for oil distribution, I gave a couple of revs....Pure sweet music. Sounded good, no hesitations, and even running. A short 1/2 mile ride confirmed The timing, and carbs were good..(Kudos to SeaFoam). Later I took it for a 10 mile ride.
Those who ride CB360's can tell you. When the carbs are synced and the timing on both cylinders is spot on, the engine comes alive. It was great that without cleaning or adjusting point, the timing was great. You can tell, as when riding steady and adding a little throttle, carb sync and timing makes a big difference. When I added a little throttle, the sound, vibration from firing, were as even as I ever heard them.
So after a Short season last year, and the Out of the Garage experience with the ignition this year, I am very pleased with the Pamco unit.
The install is in my blog in the projectds are, link below in my sig. The install is documented and if you want more info, let me know.
I like the unit, and it works. I think some improvements (Pete may have fixed some of them, I had mine before general release for testing and comments) were needed.
The 2x 3 wire sensor wiring is confusing , Actually only 4 wires are needed. I have soldering skills and some nice 4 conductor wiring to clean that up.
The plastic box the "computer" is in, is not really weather tight. I worry that liquid may get in and not get out....
The Sensor wires had no strain relief at the plastic box entry, I fixed that with some nylon ties (Black, not green, as high strength was not needed).
Pamco ignition, even with some minor flaws, is the least expensive, e-advance system you cvan get. It works (so far) and works well.
I'll update this as I go along, as with the limited time, I can't say how durable it is....But I am an optomist.
And Pamco Pete, while sometimes hard to reach, does stand behing his work and product. I hope I never go back to points. I grew up with point systems, and even on a car, they required frequent adjustments, frequent replacements. Points start wearing out the minute the engine starts turning over. When I was young, to keep my car "peaked", I used to adjust the points monthly, and they needed it. The car would run without the constant adjustment, but not as well as time went on....Think about how often you check the timing on a modern car (I never need to, but every time I checked - just to see - it was always spot on). Unless the electronics break, or you remove the points plate, your timing weill remain exactly as you set it.
I recommend the Pamco Ignition.