Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Well, I managed to turn a well mannered little bike into something that makes children cry as I go by. The last straw was when I picked up a set of CL360 pipes for $20 wrapped and painted them and put on some Emgo shorty mufflers. Damn it's loud! Too loud. I like the look and have it tuned right for the new exhaust. But, it's only a matter of time before I get busted. Any suggestions out there?
That was my first street-bike....well...mine was a CJ360 but just the same.
I swapped on the same pipes though I went with longer megaphone type mufflers, it makes a difference.
Also, you can add a small crossover pipe, either right up at the head or back by the mufflers and you get a couple benefits:
1) both mufflers will be utilized each time a cylinder fires....quieter.
2) a bit better low end without sacrificing the top end.
good lookin bike, i have the emgo shorties on my 450, they sound great, i left the baffle in them though, just loud enough to piss off the neighbors but still legal
I did not take pics when building the seat. But I used a stock seat pan, cut the foam down a few inches, cut the foam off the back, made a template with cardboard of the shape I wanted. Then cut the shape out of aluminum from the hardware store. I used pop rivets to attach it. I had it uhpolstered in marine grade vinyl by a shop locally. I polished it and used door edge trim from Autozone to make the edges clean. I use the stock seat hinge and mounted the tail light turn signals and plate to the seat with one bracket I fabbed. Drilled some holes in the pan to run the wiring. Pretty simple and cost about $80. (20 for material and 60 for uhpolstery)
Here is a pic of the underside of the seat, hope it helps. I also used the same black auto door edge trim on the bottom of the gas tank. And thanks JRK for all the info on appliance epoxy paint. I used it to do the tank.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.