Architecterre
Been Around the Block
anything for 74-77 kz400 yet?
Hi,wbergt said:I have a 1980 Honda CM400T which is similar to a CB. Do You have a rearset for this bike. I have attached a picture. If so, can You tell me the cost and payment instructions. I could use three sets. Thanks Bill
I preferred you could call in my shop so you could get some free gift. Also I could deliver to your co worker hotel. Hope you could visit us this summer.mikewerx said:might have to stop in your shop this summer to pick some up... or could they be dropped off at a local hotel if I have a co worker in town?
Hi,Architecterre said:anything for 74-77 kz400 yet?
Viet said:I preferred you could call in my shop so you could get some free gift. Also I could deliver to your co worker hotel. Hope you could visit us this summer.
Best regards,
Viet
mikewerx said:Hi Viet, Have you made any for Yamaha? XS750?
Dear DukeN,dukeninja said:Hi Viet,
Those look brilliant. Do you have any/will you be able to fabricate some for a 1980 Suzuki GS450T? And how much would shipping to the UK be?
Many thanks,
DukeN
Dear Kurt,Techno lawyer said:Viet,
Would you consider doing a set for the cb125s/Cl125s? I have a 1973.
Viet said:Hi,
Could you measure the pipe diameter so I could make a bracket to mount the rearset with out modify your stock muffler.
Thanks
Viet
Viet said:Dear Kurt,
I am now making rearset which will not depend on the rear foot peg bolting position. It means you have more choices to locate the rearset position by using a clamp bracket set (similar to cl350 rear peg bracket).
I am sending these brackets for powder coating, when it backs to my shop will send you a photo. I also making cafe racer seat ( cow leather padded with aluminum pan) for CB125.
The cost for rearset with these brackets is $US140 shipped. If you buy both seat, clipon and rearset, the cost is 299 shipped.
Thanks
Viet
Architecterre said:Finally was able to go home this weekend, it's 3/4" o.d....