I’ve got my fingers crossed!! I just bought some print filament that can take a higher temp but I’ve never used it before so don’t know how easy it is to print. I think it should be fine tho.Hope the PC oven doesn't distort it. Sweet work!
I’ve got my fingers crossed!! I just bought some print filament that can take a higher temp but I’ve never used it before so don’t know how easy it is to print. I think it should be fine tho.Hope the PC oven doesn't distort it. Sweet work!
Apologies late reply! Haven’t forgotten! Just a getting materials list down for the plastic ones. Can make them on my printer at leastI think they look great in stainless, but I’d be interested in prices for both stainless and plastic. I think they look terrific.
Sent from my iPhone using DO THE TON
Ooo I don’t know if that’s a good thing! Those grips are 3d printed! Start button, mudguard mounts, controls, inlets! It’s going to be all plastic soon! Been amazing for this single side swing arm set up I’ve been designing.Real nice job, I'm also designing and printing parts for my XV750 project.
Was looking at your headlight and thought well that looks almost like a Union Jack, just a horizontal branch, if I was English... and checked your profile...
I was just talking about your headlight, didn't know you printed other parts, will check your build !
About printing, they can be just the base, I'm designing a fuel tank, which, one's printed in negative will be the master for my mold, going for Carbon fiber...
Other parts can be printed then casted...