Recent content by arsey

Maybe cerakote is the middle ground you're looking for? No experience with it myself but it looks nice. I think it's tougher than powder but also more expensive

I /think/ support aside from the exhaust studs is a requirement in order to pass inspection, at least here in VA. 'Sbeen a while since I looked, but if that is a requirement you need to meet it'd make the decision a lot easier

well I think it's the condenser. It was mounted in an awkward spot (a zip tie was involved) and the mounting piece was right up next to where the plug lead meets the right side coil. I'm thinking the spark was going there for every time the engine didn't hit. new one on the way; here's hoping.

I havent tried that, but I looked at the plugs today and they were both pretty blackened. When the right side DOES happen to spark though it fires up fine, just that spark isn't near often enough. I figure its not the plugs then. hm. The dyna coils I've got are 3ohm. And the manual does mention...

I was mostly dreading gapping the points, just a pain setting em right for me. I didn't have to worry though because the gap for both sides is still within spec from when last I set it. Checked the timing with a bulb hooked up to the points like the manual says and it's golden too, both sides...

Yeah I've been dreading re-timing the thing, but I really should and hope for the best. I read up a bit on the PAMCO electronics; can't wait til those are in stock again. Thanks guys

hm. Were it the heat doing it I'd think both coils would flake out on me, not just the right side, twice now.. thoughts? i could probably test the "dead" coil just to make sure it's dead, and not some terrible wiring thing

On my cb350 the right side wasn't getting spark, so I swapped the two coils and it fired up fine, with the left one sparkless. (these were dyna coils bought new a little while ago.) I replaced the seemingly dead coil with a new one a month or so ago, and both sides fired fine. But I tried...

ah man check out that sweet shopping cart though

these work nicely: http://www.siriusconinc.com/pro-detail.php?pid=&product_id=1086

Here's the back & inside. The fleece (I guess?) lining zips out, and the inside is a neat blue color. Don't have a measuring tape handy, will take those measurements when I get a chance. Somewhere out there is a gray 42, or so I keep telling myself. The race is on!

I've held onto this jacket for a while thinking I could bulk up and fit it, but need the dollars instead. I've got the same jacket but in black anyhow Bought unworn, and stayed unworn. Went from tim -> another member -> me. Here's the lowdown on it, via Tim's schott sleuthing: Just asking...

Payment sent, also! Thanks

Got a yamaha and a black honda left? I'd like both, if so

Re: CB350 Cafe...The 7 Year Bitch! also curious! how goes it?