Search results

Whats the advantages and disadvantages of flux core vs. shielded gas. Is gas-less mig or shielded gas the way to go? Or does anyone have any other suggestions?

Going riding tomorrow and looking for a good photography app, know of any?

So I was just over at www.pipeburn.com and they did a short interview with a photographer and designer named Mondo Lulu. There was something said about a TV series that involves www.dotheton.com. Has anyone heard anything else about this? ???

I have a 75 cb360, on the way to work this morning the right cylinder started missing, I finally made it to work and while the bike was still running I pulled the wire and put it back on just to see which cylinder it was and nothing happened, ten kicks later I had the bike running again and...

Has anyone cut down the stock seat foam? I have been thinking of trying it? Any pics or ideas?

Look at the beautiful gift I received today! ;D ;D ;D ;D Born Aug. 23, 2010 6lbs 3oz. at 3:31 pm My mother (the new grandma) holding her

I have been working on my garage for the past couple of weeks, 30x36'. Just brainstorming trying to get some ideas of what will make it badass!! I will post some picks when I get home.

I'm from Staunton va. Don't know if I fall in the east coast or dirty south, I put a post out in the east coast for anyone wanting to ride the parkway or around this area and nobody replied back, so I'm trying here. Looking for people around the Staunton, Charlottesville and surrounding areas...

Is there anyway I can tune the sound of my stock exhaust to be louder and deeper, or are straight pipes really as bad on the bike as everyone says?

So I'm on the way to work this morning and I get to the first stoplight and my bike starts to backfire, then continues to do it only at idle the whole way to work every time I stop, no big deal just thought it was being stupid because it was cooler, at lunchtime and a when I got off today at 6...

Got to work this morning and noticed that my hand had brake fluid on it, it's leaking down the lever. Is there a gasket, o-ring, or seal I can replace or do I have to rebuild the master cylinder?

I wanna ride!!!

Is there any way to adjust the front brake on a cb360t, it squeaks and its also a little squishy, i have bled it 50 times!! better but still squishy thanks, eric

Hi Guys. I'm Eric, I live in Va. I've been a member for a little while, just observing. I have had lots of bikes from a F4 to a Busa. I've always wanted an old cafe project and on my anniversary in May my wife bought me a '75 cb360. I've been tinkering with it ever since. Got it running and...

Hello I'm Eric This is my first post even though I've been a member for a little while, I have just been observing. I have a '75 cb360 and I just finished installing a set of clubmans. Hoping for a test ride I pull in the clutch, hear a pop and now the clutch lever is stuck and the kick start...