1973 BMW R60/5 Cafe Project

[98kellrs]

ManizieRacer the springs in my Mikuni's will return the throttle. I would not say it is a strong return but it does return. When I got the carbs from Rocky Point they also sent along new cables for the carbs. Given the level of tension I have in my throttle return it would not take much for me to have your problem.

I couple of things to think about that may help: Are you using new cables? Also I noticed I had to have the throttle assembly really cleaned well to make sure it moved freely. did you change out the bars as 7/8" bars are a little larger in diameter then stock and that can cause the throttle grip to not turn freely. I had to sand down the bar under the grip some to make sure it turned without touching the bar. I also noticed on mine that I have to have the Throttle Grip Tensioner out as it does not take much to have it get hung up and not return.

Hope this helps

That's good to know that they do have enough push to return the throttle. Anything is better than what I have right now!

Thanks for the tips! My cables were new with the carbs which I think the PO installed less than a year ago, however I will relube them just to make sure. I hadn't thought about the possibility of aftermarket bars, so I will measure these and shave them if needed too. No worries about the Throttle grip tensioner as the screw is missing anyway..

I love the red frame and the toaster tank!