So here's a big post!
Painted the tank and guard, just a straight gunmetal with a lot of clear over, using standard single pack rubbed back with wet and dry and polished.
Had some logo's computer cut out of vinyl and cleared over them.
Installed the Danmoto guage, easy enough but have some issues with reading the rev's so may need to make a little filter up for the signal. Still need to do the speed sensor too.
Looks neat and I'm pretty happy with it all.
Wrapped pipes
Together!
The observant may notice the lack of rear brake! Its coming!
Pretty happy with the look I think.
A little loud with the pipes, but bearable.
Will change the master cylinder and the brake lines later on.
Love the speedo and triple clamp, one of the best parts of the build I reckon
Logo looks good, there were issues trying to get enough details in it, due to the accuracy of the vinyl cutting, worked out well though.
So a few items left to do:
Rear brake lever
Speed sensor locating
Bit of mucking around with wiring, general tidy up under seat etc
New Brake lines, ideally a single that splits, just like my Ducati to replace the balance block which is UGLY
Adjusting muffler fit to header, a little on the loose side at the moment. Pack them out a bit with something?
Ride her!