Another CB360

[akretz360t]

It's coming along, slowly...

Still needs:
-Wiring
-Front Brake
-Seat foam
-Petcock
-I'm sure I'll think of something else

Just looking at it stresses me out, anyone want to buy!?! I'm in the Portland Area.

 

[zshulk56]

Are those the stock exhaust if not would you mind telling me where you got them?

 

[rubber-side-down]

sssssaaaawwwweeeet! love it

but info on ur seat did u buy(hope so, so i can buy one) or build it?

 

[dlv]

Another CB360

Very nice! Would love some more info on the seat. Did you cut the back loop? How did you mount it?

 

[legendary_rider]

You're almost done! All the hard stuff is over. I say finish it bud. It's gonna look sweet.

 

[akretz360t]

Ah Yes, I'll be finishing, I just get stressed thinking about the money that goes into this thing haha.

Seat can be found here: http://www.caferace.com/Merchant2/merchant.mvc?Screen=CTGY&Store_Code=C&Category_Code=RRBT it's pricey, but it fits like a glove with the stock tank. (it actually came extra with the bike when I bought it)

To Mount I used the bolt holes where the battery tray used to bolt up and rear fender support, I took some aluminum and molded it up under the hump to support where I'll be sitting and the hump and stop any vibration that may happen while riding, used some rubber stoppers to raise the seat.

As for exhaust, they too came with the bike and I am not sure where they were sourced (yes, it came with A LOT of extras) I know DCC has some stainless reverse cone exhaust. Maybe emgo has something similar?