Another new control switch question.

[djmaynard]

Good morning, after trying to find older but in good condition control switches for my 82 Honda cb900, I was debating picking up something different.

Not sure if those could work, but it's simple and sharp. I have new bars installed and everything else has been replaced but can this de done or is the wiring not going to work?

Sent from my iPhone using Tapatalk

 

[vandito.cb]

as long as they have wires for each function, i.e. turns, horn, kill and whatever else you plan to run, yes. you'll just have to pull up the wiring diagram for them as well as your bike to figure out what goes where.

 

[cqyqte]

They fit 1" bars unless you can get them for 7/8"

 

[djmaynard]

What if they were pro tapered from 1.25" to 7/8"? Wonder if it would fit right


82 Honda CB900C is my first attempt of a bike upgrade

 

[hillsy]

What if they were pro tapered from 1.25" to 7/8"? Wonder if it would fit right


82 Honda CB900C is my first attempt of a bike upgrade

The taper reduces from the mounts out to the bars, so the bars are still 7/8" as far as the controls / grips are concerned.

 

[djmaynard]

The taper reduces from the mounts out to the bars, so the bars are still 7/8" as far as the controls / grips are concerned.

Thank you hillsy


Sent from my iPhone using Tapatalk