Anyone know a good machine shop in the Philly area?

[unionkane]

Hey now,

So after discovering an oil leak from my cylinder head gasket (I don't know if that's the correct term for it or not but I'm going with it) I figure it's time to pull the cylinders and have them honed.

Anyone know of a good shop in the PHL area that can do them for a reasonable price?

Also, does anyone know if there's a step by step to disassembling the top end online? I've searched through pages of results but "top end" is fairly common.

Any info is appreciated.

Thanks,
Mike

1974 CB450 K7

 

[SrgtBear]

You'll need to find a service manual. They usual do a pretty good job at showing how to take apart the top end in the right order. As far as honing I would just buy a honing tool and do it yourself. It's not like your getting actual machine work or getting your cylinder bored out.

You need something like this but I don't know if a 4" inch honing tool is too big. The website says "from 2" to 7" diameter".
http://www.harborfreight.com/4-inch-engine-cylinder-hone-97164.html