HerrDeacon
Over 1,000 Posts
Just wondering if anyone has any cheap ideas for bending metal? I'm talking about cheap or diy metal bending brakes. I've looked around for small cheap ones and even they are too much for me to spend, especially with the little bit of bending I'd do with it.
Right now I just have a small vise and use that to help pound some angles into sheet metal but the results are usually not the best or even. I just need something to help make some small things like license plate brackets, gauge mounts, etc. I've done these in the past using a vise but wondering if there are any better, less frustrating, methods to help save me some grief.
Right now I just have a small vise and use that to help pound some angles into sheet metal but the results are usually not the best or even. I just need something to help make some small things like license plate brackets, gauge mounts, etc. I've done these in the past using a vise but wondering if there are any better, less frustrating, methods to help save me some grief.