Hey Goose, I know you are only capable of bending a 9 inch hoop outside edge to outside edge, but I was wondering if when bending the hoop you could bend 90 degrees, leave a half inch of straight tube, and bend the rest 90 degrees. This in theory should give a 9.5 inch outside to outside hoop with a very small flat/straight spot at the vertex. I don't know if this is something you would be capable of, but I've been searching all over the web an calling around town and it seems that nobody can produce a 9.5 inch outside to outside hoop. I think I may have contacted you on ebay as well. Let me know, thanks.