Carb needle retainer clips - Not the "e" clip for PZ19

Maritime

Well-Known Member
Ok, tuning the new Hyosung carb last night and got it working close but wanted to raise the needle a bit as it was lean at WOT, pulled over, pulled slide, pushed on the needle to pop the retainer and had my hand out to catch it like 1000 times before only to have the little fucker go flying into the ditch. So I have been trying to buy some of them and they are not on any sites. I bought a full rebuild kit for the carb to get one but I want like 10 of the things to have for when this happens again. I managed to ride home but it now acts funny on decel as the needle is likely not going down correctly. Anyone know where you can get these? Seems like something you should be able to buy like the "e" clips for the needle position,. can buy them in bulk easy.

Cheers

Maritime
 

Tim

Administrator
Staff member
I think I saw something like that in the slide of the tiny carb on my Honda ST90
 

Maritime

Well-Known Member
Be the same, those go for $15 plus shipping on Ebay BTW. It's for a 50 CC 2 Stroke. I got it so close to running perfect only to lose that clip. I'm between an 82 and 85 jet, I need to put them each in and raise/lower the needle till I get it perfect.
 

Maritime

Well-Known Member
I have the one from the stock carb but it doesn't fit the aftermarket one. the stock carb has a larger diameter slide so the clip is the same shape only much larger
 
Top Bottom