kief90
Engineering Student
Hey fellow toners! My bike is nearing completion and I need a little bit of your help. ;D
I finally installed my drive chain on the bike and when I set it off of its center stand it won't move in neutral or when the clutch lever is pulled in. The chain isn't too tight and set to what the factory specs are.
Any advice or ideas what the problem might be? I am completely stumped at the moment. Could it be a clutch problem?
EDIT: It started just fine when I had the chain off of it. I need to carb sync it because the idle is high but besides the locked wheel it works fine.
I finally installed my drive chain on the bike and when I set it off of its center stand it won't move in neutral or when the clutch lever is pulled in. The chain isn't too tight and set to what the factory specs are.
Any advice or ideas what the problem might be? I am completely stumped at the moment. Could it be a clutch problem?
EDIT: It started just fine when I had the chain off of it. I need to carb sync it because the idle is high but besides the locked wheel it works fine.