redwillissuperman
Keep it simple- engine, wheels, bars
I'm creating a set of SuperManifolds for the CB360 to mount PWK or VM Mikuni carbs.
My number one issue is moving the carb away from the fuel petcocks. I also want to add a 1/8-inch NPT port for hooking up a vacuum gauge.
The manifolds will be aluminum with o-ring seals on the engine side. I was going to go simple on the carb side with a silicone coupler.
Right now I have two choice for location- one a little tighter than the next for choke access.
Thoughts?
Short
Long
My number one issue is moving the carb away from the fuel petcocks. I also want to add a 1/8-inch NPT port for hooking up a vacuum gauge.
The manifolds will be aluminum with o-ring seals on the engine side. I was going to go simple on the carb side with a silicone coupler.
Right now I have two choice for location- one a little tighter than the next for choke access.
Thoughts?
Short
Long