Hey All,
I have completed the programming to remove the handlebar mounts from the stock CB400F upper clamp. I am also now a distributor for Tarozzi in Canada, so I can also supply clip-ons to go with the clamp machining, and I have taken some of the guesswork out of it by pre-checking the fit.
There is a better write up at my site http://www.denoonsp.com/machined-triple-clamp.htm
I can do the same machining for pretty much any set of clamps, but to keep the costs down I need to do at least 4-5 clamps of the same model to justify the programming and set-up time.
Thanks
Rick Denoon
I have completed the programming to remove the handlebar mounts from the stock CB400F upper clamp. I am also now a distributor for Tarozzi in Canada, so I can also supply clip-ons to go with the clamp machining, and I have taken some of the guesswork out of it by pre-checking the fit.
There is a better write up at my site http://www.denoonsp.com/machined-triple-clamp.htm
I can do the same machining for pretty much any set of clamps, but to keep the costs down I need to do at least 4-5 clamps of the same model to justify the programming and set-up time.
Thanks
Rick Denoon