Hi, I recently purchased a new project that being a Honda CB750f2. It has a fully fitted cb954rr front end including brake system and wheel.
The rear swingarm I have to mirror the front end is from a CB400SF.. This is where I’m struggling. The S/A at pivot point is narrower than the stock so will need spacing accordingly. What considerations do I need to think about when having bushings/spacers made up. The rear wheel is the CB400SF wheel so no lateral movement available when considering sprocket alignment, this will have to be done by modifying sprocket carrier at the rear and offset sprocket at the front if required?
Any help or advice would be very welcomed please
Thanks
Alan
The rear swingarm I have to mirror the front end is from a CB400SF.. This is where I’m struggling. The S/A at pivot point is narrower than the stock so will need spacing accordingly. What considerations do I need to think about when having bushings/spacers made up. The rear wheel is the CB400SF wheel so no lateral movement available when considering sprocket alignment, this will have to be done by modifying sprocket carrier at the rear and offset sprocket at the front if required?
Any help or advice would be very welcomed please
Thanks
Alan