westgateok
New Member
Hey guys, I have a 1981 CM400E that I absolute love working on. Recently I stripped it down a bit to really give it a good clean, fixed the dent in the gas tank and it is now prepped for paint. I marked all wires when I removed the rear bumper, and put it all back together yesterday. Everything worked except the brake light is always on. Pushing either of the brake levers does not cause anything to happen with the light. I assume that I must have missed a ground or something so I re-checked those, fiddled with the rear brake "plunger" to see if that was out of adjustment, and checked to make sure that the front brake wires had good contacts. Everything looks right I just can't seem to figure it out. Any advice?