chickenStripCharlie
Coast to Coast
Hi guys. How much runout is considered normal on the rear sprocket? I cant be 100% certain if it's the sprocket or the cush drive itself but there is definitely some run out. The wheel spins true.
The sprocket is larger diameter than the other sprocket I tried so it's more noticeable, but both show some runout.
I have a dial indicator but no good way to set it on the cush drive as the sprocket mating surface isnt a continuous piece.
The wheel is in place and tight. So I would have expected all the slack out of the cush drive to have been taken up.
I would say at the tip of the largest sprocket its maybe 1/16" to 1/8"? Eye balling it. I'll get the dial indicator on it tomorrow when I have time to swap the sprockets.
Thanks!
The sprocket is larger diameter than the other sprocket I tried so it's more noticeable, but both show some runout.
I have a dial indicator but no good way to set it on the cush drive as the sprocket mating surface isnt a continuous piece.
The wheel is in place and tight. So I would have expected all the slack out of the cush drive to have been taken up.
I would say at the tip of the largest sprocket its maybe 1/16" to 1/8"? Eye balling it. I'll get the dial indicator on it tomorrow when I have time to swap the sprockets.
Thanks!