Custom Reat-Sets for my CM450 Cafe

jaredc7

Get busy living.
Here are the rear sets I had plasma cut for my 1982 Honda CM450 Cafe... Lots of other things to resolve with this project besides just foot position... outboard supports on the single swing arm, relief area for the chain, subframe supports, etc. I tack-welded everything in position, then took it to the pros to finish up.
 

Attachments

  • CM450C_2016-10-21_1.JPG
    CM450C_2016-10-21_1.JPG
    1.8 MB · Views: 326
  • CM450C_2016-10-21_3.JPG
    CM450C_2016-10-21_3.JPG
    1.6 MB · Views: 320
  • CM450C_2016-10-21_4.JPG
    CM450C_2016-10-21_4.JPG
    1.2 MB · Views: 334
  • CM450C_2016-10-21_11.JPG
    CM450C_2016-10-21_11.JPG
    1.3 MB · Views: 314
  • CM450C_2016-11-13_1.JPG
    CM450C_2016-11-13_1.JPG
    1.3 MB · Views: 330
  • CM450C_2016-11-26_2.JPG
    CM450C_2016-11-26_2.JPG
    1.8 MB · Views: 323
  • CM450C_2016-11-26_3.JPG
    CM450C_2016-11-26_3.JPG
    1.6 MB · Views: 322
  • CM450C_2016-11-26_4.JPG
    CM450C_2016-11-26_4.JPG
    1.5 MB · Views: 343
Here's my build thread too...

http://www.dotheton.com/forum/index.php?topic=55387.msg851532#msg851532
 
Back
Top Bottom