K
Kamn
Guest
I have an old thread on another CX that Im doing but took a break because I bought this junker for a few hundred bucks........I know its a little pricy but everything is in Ontario Canada
I got to work on it immediately and srtipped it down to nothing. I needed a ride in the meantime and had a 4 week turn around plan on it........yeah right.......took 7 weeks instead because work kept me from doing what I needed.
Other than powder coating the rims, I did it all.
Rebuilt forks with race tech springs and emulators
motor got a new cam chain, tensioners, gaskets and seals throughout + a coat of satin paint and stainless bolts
GK clutch and heavy duty springs
new cables
clip ons and grips
new rubber front and rear
cross drilled rotor and new sintered pads.....with a SS brake line and new master
sand blasted the frame, swing arm, kick stand, centre stand, triples
New headstock bearings
painted the frame and all the other parts (some with epoxy paint in satin black)
Gas tank was a bastard (4 small dents but creased) and rattle can paint experiment for me (not bad)
A friend turned out some new pegs plus pegs for the shifter and brake, I made the or altered the original brake and shifter arm
New exhaust from heads back to mufflers
AND I have a set of Murray 34mm Mikunis on it
Tucked the electrical under the seat (still need to clean that up a little)
Made a new seat pan, foamed it, and stitched up my own cover (again its was a learning lesson about stitching).......will be making a new one soon that is a little more tucked in on the sides (not so wide)
Here it is (sorry they are cell phone pics)
Now I think I will take a little break and just ride the crap out of it and then get finishing up on the other project I have started
Cheers
I got to work on it immediately and srtipped it down to nothing. I needed a ride in the meantime and had a 4 week turn around plan on it........yeah right.......took 7 weeks instead because work kept me from doing what I needed.
Other than powder coating the rims, I did it all.
Rebuilt forks with race tech springs and emulators
motor got a new cam chain, tensioners, gaskets and seals throughout + a coat of satin paint and stainless bolts
GK clutch and heavy duty springs
new cables
clip ons and grips
new rubber front and rear
cross drilled rotor and new sintered pads.....with a SS brake line and new master
sand blasted the frame, swing arm, kick stand, centre stand, triples
New headstock bearings
painted the frame and all the other parts (some with epoxy paint in satin black)
Gas tank was a bastard (4 small dents but creased) and rattle can paint experiment for me (not bad)
A friend turned out some new pegs plus pegs for the shifter and brake, I made the or altered the original brake and shifter arm
New exhaust from heads back to mufflers
AND I have a set of Murray 34mm Mikunis on it
Tucked the electrical under the seat (still need to clean that up a little)
Made a new seat pan, foamed it, and stitched up my own cover (again its was a learning lesson about stitching).......will be making a new one soon that is a little more tucked in on the sides (not so wide)
Here it is (sorry they are cell phone pics)
Now I think I will take a little break and just ride the crap out of it and then get finishing up on the other project I have started
Cheers