DIY Rearsets......

Im out of solid pegs for a little bit. But i still have folding pegs ready to go. Ill get word on solids in a day or two.
 
I was going through some of your posts and saw that you have a kit for xs650's. Well I would like a set BUT I have mag wheels with rear disk and I am wondering if they will work?
 
ejc2g said:
I would like a set, I sent a PM a while back but never heard, can you send me some PayPal info?
Click to expand...

Very sorry for a lack of response. Are you looking for a Solid , or folding kit?

Cloyd, My kit is designed to utilize your stock brake pedal. If that actuates your MC on the inside of the frame, than it should work. I am looking into it a little closer for a more definite response.
 
delirium trigger said:
fit a cb350?
Click to expand...

I have a specific kit for CB350's.
$185 plus Shipping. comes with foldingh pegs, mounts, linkage, hardware. Everything needed, except a splined shift arm.
 
Great! Folding set with Linkage goes for $142 plus shipping. What is your Zip, and Ill figure on shipping costs.
 
What are you guys using as a spacer on the back side between the shift lever and frame? As seen in this pic
4086b6ee-aa9e-7188.jpg
 
Miltownchris

Shipping will be $8.50.
$150.50 total. I can send an invoice, if you like. or you can pay direct. at durgam605@att.net
Thanks, Kris
 
modifiedamerican said:
would these be able to be used on my kz750?
Click to expand...

As long as you have a secure place to mount them. Be leary of a kick starter though. im not sure if that bike has one or not. Also check on brake actuation possibilities. Its usually best to re use thestock pedal, just cut and rotated with a hole in it, for the linlage.
 
Durgam_K said:
As long as you have a secure place to mount them. Be leary of a kick starter though. im not sure if that bike has one or not. Also check on brake actuation possibilities. Its usually best to re use thestock pedal, just cut and rotated with a hole in it, for the linlage.
Click to expand...

I forgot to check for kickstart clearance. I'm too late now. I'll either have to bump-start it or find a kickarm that hinges and might clear the pegs and brake pedal.
 
eyhonda said:
I forgot to check for kickstart clearance. I'm too late now. I'll either have to bump-start it or find a kickarm that hinges and might clear the pegs and brake pedal.
Click to expand...

What did you put yours on? I cant remember.
 
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light
    • www.jadusmotorcycleparts.com
    www.lostapostle.ca/
    www.sparckmoto.com

    Spread the Love

    Back
    Top Bottom