How to fit blinkers
- Thread starter yozzer74
- Start date
vandito.cb
Been Around the Block
yozzer74 said:
pull up a wiring diagram for your bike as well. the wire colors usually won't match with your factory wiring.
what kind of bike is it?
vandito.cb
Been Around the Block
In principal they are typically wired the same way.
+12v to the relay
Other side of the relay (load) goes to the indicator switch - Brown and white on that switch.
The Brown and dark green go to the power side of left and right indicators and teh indicator bulbs are grounded.
If you want two idiot lights, wire one in to each side. If you want one idiot light to operate when either side is blinking, you have to add diodes to keep the two sides apart.
Easy peasy. The trick is to find those wires in your loom and to connect them correctly. Much easier if you wire from scratch.
+12v to the relay
Other side of the relay (load) goes to the indicator switch - Brown and white on that switch.
The Brown and dark green go to the power side of left and right indicators and teh indicator bulbs are grounded.
If you want two idiot lights, wire one in to each side. If you want one idiot light to operate when either side is blinking, you have to add diodes to keep the two sides apart.
Easy peasy. The trick is to find those wires in your loom and to connect them correctly. Much easier if you wire from scratch.
That color code is a bit unfortunate. Dark green on your CB750 is ground. Orange is left signals and light blue is right signals on your bike. Black is power. White and Dark blue on the bike's harness goes to your headlight.
