afiendishthingy
New Member
Alright ladies and gents, I finally got my bike in the road, but am having a couple of problems.
My bike runs great, until it gets to full operating temperature and giving me two specific faults.
1. After a while, when I am at a stop, shift into first and my bike bogs terribly until I stick it out and slowly gain speed, then boom, I'm good to go. Or I have to hold the clutch, rev, then dump the clutch to go.
2. It takes forever to get back down to idle speed (it will stay at around 5000 rpm). The only way I get it to go back down is to just keep it in gear until I almost stop or stop, poor a small load by releasing the clutch a tad, OR by cutting power for a split second (only done while I'm working on it in shop).
A few things, I cleaned and inspected everything in the stock carbs. Everything works great, slides slide without sticking and it seals completely. From what I can tell, the cable/cables work great. They go back to the stops without hesitation.
Only mods are uni pods, stock jetting. I didn't think it would be these, because I had on stockers(dirty ones mind you) and it did the same thing.
Any help would be greatly appreciated. Any jet recommendations would be great too if that is what my problem is.
Thanks!
My bike runs great, until it gets to full operating temperature and giving me two specific faults.
1. After a while, when I am at a stop, shift into first and my bike bogs terribly until I stick it out and slowly gain speed, then boom, I'm good to go. Or I have to hold the clutch, rev, then dump the clutch to go.
2. It takes forever to get back down to idle speed (it will stay at around 5000 rpm). The only way I get it to go back down is to just keep it in gear until I almost stop or stop, poor a small load by releasing the clutch a tad, OR by cutting power for a split second (only done while I'm working on it in shop).
A few things, I cleaned and inspected everything in the stock carbs. Everything works great, slides slide without sticking and it seals completely. From what I can tell, the cable/cables work great. They go back to the stops without hesitation.
Only mods are uni pods, stock jetting. I didn't think it would be these, because I had on stockers(dirty ones mind you) and it did the same thing.
Any help would be greatly appreciated. Any jet recommendations would be great too if that is what my problem is.
Thanks!