Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I couldn't get my cb500 to idle after messing with the both the master idle adjustment and the air/fuel mixture screws on the individual carbs, so I tried something else. I just took the spring off the master idle adjustment so I could screw in the screw as far a I wanted. Now it's idling anywhere between 1-2 grand depending on where I put it. Granted after riding a while the screw starts to come loose because it's not held by the tension of the spring anymore, but for the most part it's seemed to work. Any thoughts on if this is a solid fix or should I find another more sound solution.
You're probably right - thinking about it some more they're non CV carbs so the adjusters at the slides might be adjusted all the way down which in turn requires the throttle shaft to be further up than normal.
One rule of thumb that has served me well with carb work and older bikes in general: When putting things together that are adjustable, the final setting should be somewhat close to "the middle". Usually, taking an adjustment to one extreme or the other in order for the bike to work correctly means that something is broken, worn, or being negatively affected by something else.
Yeah good advice. I know for a fact the carb innards are pretty worn and need replacing. Can any of you guys speak to the generic rebuild kits you can find on eBay? I'm leaning towards one of those.
I have used them on a few occasions and they have worked out fine. But...perhaps I was just lucky as I have heard some opposite reports. However, going with a kit from someplace like Dime City is pretty much guaranteed to be superb or they will replace it. I have been known to buy one generic kit from ebay to see if it is as advertised, then purchase the other 3. Spend less and roll the dice...or spend more for peace of mind...the age-old question!
I hear ya. I'm building on a budget though and the $40 kits speak to me a little better than buying four $25 kits from DCC. No hurry though. I'll do some more research.
Have you cleaned the carbs? Take them apart and spray carb cleaner through every orifice and jet before you buy new parts. Get seals and O rings first.
Yeah I've cleaned them. Some of the o rings on the jets are going bad though and not creating a good seal. Also I wasn't sure but should you be able to see long ways through the slow jet? ( I think that's what it's called ) probably makes me sound like a dumbass but I couldn't see longways through any of them after a good scrubbing so I just put them back in as is. If so, that could be my problem too.
Yeah I've cleaned them. Some of the o rings on the jets are going bad though and not creating a good seal. Also I wasn't sure but should you be able to see long ways through the slow jet? ( I think that's what it's called ) probably makes me sound like a dumbass but I couldn't see longways through any of them after a good scrubbing so I just put them back in as is. If so, that could be my problem too.
If budget is really tight, you could purchase just the viton o-rings from various internet sources, or get lucky at a hardware store. If you do enough research on parts lists and diagrams, you can eventually find the actual measurements of the o-rings. Give everything else a real good cleaning and maybe just have to purchase new float valves if they are a problem?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.