led turn signal problems

[zimm]

so we out them on a stock cb350 and when you turn one side on all 4 come on, we checked the switch to make sure it was working proplery no problen there,made sure all the wires war hooked up corect so where do we go next?
check grounds? is it too little of a load and backfeeding thur a ground curcit? i think if it was there would be more problems?
i know there is not to little load to make flasher work

 

[loudest143]

I might try unwiring them one at a time. Divide and conquer. You may have only ONE wired incorrectly, and by unwiring one, you can test the circuit. If you have the same problem, put that one back in the circuit and then remove another one. Short, easy test. It will tell you whether or not they are all wired the same. NOTE I said wired the same, not correctly! You may have a simple wiring issue. I think you mentioned that the flasher doesn't work, as the LEDs will not drive the stock flasher. You are correct sir! Dunno if that effects the circuit on your bike, but on mine it would NOT effect whether or not one side would light up or not.

Let us know of your progress.

loudest143

 

[Korr]

Sorry stupid question, but did you get load equilizers for them? I had the same problem when i tried led's. Too much hassle for me so i just went back to filament bulbs