ProSimex
RUN SCREAMING!!!
I got my HHB PMA kit in the mail a few weeks ago and now that I finally have everything running nicely enough I decided that it was time. I finally scrounged up the testicular fortitude and brok out the tools. I had bought a crummy 2 jaw puller from crappy tire that I understood would do the trick.
It didnt.
After getting it all opened up I put the puller on and got to work. Eventually wound up bending the puller handle around like spaghetti. After checking to make sure I didnt bend or crack the origional rotor I buttoned everything back up and all is well in the world. But I do need to get this PMA swap done.
If someone has a proper rotor puller I can borrow Ill happily pay the shipping to and from k2g1v2, and send it back. If you're in Toronto (Noel, Tim, cough) I can swing by after I make my steel deliveries in Hamilton during the week.
It didnt.
After getting it all opened up I put the puller on and got to work. Eventually wound up bending the puller handle around like spaghetti. After checking to make sure I didnt bend or crack the origional rotor I buttoned everything back up and all is well in the world. But I do need to get this PMA swap done.
If someone has a proper rotor puller I can borrow Ill happily pay the shipping to and from k2g1v2, and send it back. If you're in Toronto (Noel, Tim, cough) I can swing by after I make my steel deliveries in Hamilton during the week.
