Need some help identifying a couple parts

[ksprzk]

So i've done a pretty good job labeling the crap out of every part that's come off my CL360 i'm restoring. However a couple parts slipped through the cracks. Anyone know what these belong to?

A-

B- (2 pics, and it's not the gas cap seal)

C- (pretty sure i had this labeled, took it out of the bag to clean it, and lost the bag...)

 

[mark13018]

I think that rubber goes to the air boxes or the frame tunnel for the air boxes and where they connect together. Is the bolt with nut an axle? You can't tell sizing well from the pic. Is there a hole through the threads of the bolt?.. I'm unsure of the bolt with the spring.

 

[skatetheame]

I think C is one of the engine mount bolts. Not sure what the others are

 

[ksprzk]

C is 14mm. No hole through the threading. I think it is an engine mount however i just didn't see where it went...which is irritating cause i'm sure i wrote it on the damn bag it was stored in.

Didn't see a spot on the air filter for the rubber gasket?

 

[mark13018]

There are two or three pairs of flat black metal pieces that bolt onto frame/engine first then the longer bolt goes through that.

 

[Traveler350]

B looks like the rubber grommet the goes on the headlight bucket. C looks like and engine mount bolt.

 

[ksprzk]

Traveler350! That's it!

Thanks!

Anyone have a guess on that damn spring screw deal?

 

[brycegp]

A might be an idle adjustment screw. looks exactly like the one on my CB750...

 

[whynot]

The spring screw thing is the throttle stop screw.

On the bottom of the right hand control.

Was only available on certain models. Don't know which ones.......I have one on my 750, but they aren't original to the bike.

On my Harley, I use it as a cruise control on long trips.

 

[ksprzk]

That's it Budlite282! I actually have one on my Harley as well.

Thanks everyone!