J-Rod10 said:Out of curiosity, how many ops you running on the triple?
jag767 said:My guy says 4. Finished part, well almost.
crazypj said:The important bit, what's it going to cost?
crazypj said:If it comes in much more than $125 you'll still sell quite a few but doubtful to the majority of people on here.
Probably 'worth' $250 or more, I know you have to start with a very expensive block/plate, material and machine time are going to be a bit high?
You already checked some of the other yokes people are making here? CB350/360 is known issue, they go around $100~$120 last time I looked.
I
crazypj said:I just threw out some numbers to see where it went, knowing you would have already priced the competition.
Personally I think $130 for flat plate is way overpriced, the design you have is going to need a much thicker piece to be able to machine all the curves. Good looking piece is going to cost a lot more. Probably be best to make a replacement for USD forks first, new stock piece would be damn expensive simply because the forks are newer (plus, as I already mentioned, there ain't too many different sizes) If tey were drilled for 'risers/bar clamps it would open up a market that doesn't exist at present, USD forks with MX/flat track bars. To get a neat looking handlebar mount is pretty difficult and stock top yoke is real tin where they get drilled for bar mounts (Used to work with a bunch of 'stuntaa's')
crazypj said:That's a good price considering what a genuine TD/TZ costs. They have been bid up to crazy prices. It's so far outside my price range that I don't even look any more though..