Nuts/bolts kits?

[flatpick13]

Does anyone know of any complete kits for new nuts, bolts, and washers? I'm specifically looking for a 1980 CB750F. I've found some kits for specific assemblies (like these https://alloyboltz.com/product/honda...en-engine-kit/), but pretty much all of my nuts and bolts (minus those large/long pieces that go through the frame for the engine mounts and swing-arm) are rusted, stripped, or just trash. I'd like to get a whole set instead of buying them piecemeal. Thanks in advance!

 

[Jimbonaut]

I used the same bolts from alloyboltz for the engine covers, but couldn't find complete kits for the engine cases etc. I ended up cleaning all mine and getting them zinc plated in the end. Not an option I guess if your bolts are toast but maybe something you can do to the ones that are salvageable.

 

[teazer]

I usually clean all the hardware and have it zinc plated, but replace the cover screw with stainless or aluminum cap screws to tidy up the appearance.

If you do teh same thing, take a little extra time to check all teh threads and bolt heads and clean up any damaged threads and bolt heads so they look like new when they come back.

 

[flatpick13]

Ok, thanks. I'll probably do the same, was just hoping to find a kit that had them all instead of keeping track of a shopping list as I take this bike apart.

 

[Jimbonaut]

It wasn't silly money to zinc plate the bolts for my bike (an '82 CB750F) - I got the lot done for around $50, and that was for every single piece of hardware on the bike, not just engine (frame, caliper bolts, pedals etc). Prep was a bigger job. Bear in mind that you'll get back what you give - I cleaned and polished every bolt so that the nickel plate came back looking really shiny. If you give them roughly-finished bolts the zinc may not come back looking too shiny.