alacrity
New Member
anyone done this? How did it go?
Also - they say the usually leaky oem o-rings on the cb550s that always need replacing on a top end job are not needed with their gasket (they have "bosses" = built up areas of the head gasket where the orings would go). Wondering if anyone has had good luck with these sealing the head/cyl interface correctly.
Also - they say the usually leaky oem o-rings on the cb550s that always need replacing on a top end job are not needed with their gasket (they have "bosses" = built up areas of the head gasket where the orings would go). Wondering if anyone has had good luck with these sealing the head/cyl interface correctly.
