eye_less_82
http://backyardcustom.tumblr.com/
Hi everyone,
Firstly I want to thank the whole forum for all the useful information eveyone has put on here, its been so helpfull especially for a first timer like myself.
My question is related to the Suspension on a Honda CB350. My intention is drop the back end of the bike without having to chop and weld a hard tail onto the frame. I was planning on lowering it by removing the original suspension at the rear and replacing it with steel bars, which would make the back end rigid without the need for welding.
Can someone recommend a suitable steel size (in metric measurement) or point me in the direction of a post in this forum where someone has done this?
Thanks in advance
Firstly I want to thank the whole forum for all the useful information eveyone has put on here, its been so helpfull especially for a first timer like myself.
My question is related to the Suspension on a Honda CB350. My intention is drop the back end of the bike without having to chop and weld a hard tail onto the frame. I was planning on lowering it by removing the original suspension at the rear and replacing it with steel bars, which would make the back end rigid without the need for welding.
Can someone recommend a suitable steel size (in metric measurement) or point me in the direction of a post in this forum where someone has done this?
Thanks in advance