Small bikini headlight fairing and seat

[bdn3d]

Hello all, I'm looking for a small bikini headlight fairing and cafe seat. Preferably made out of steel or alloy. Depending on past projects and photos I will either pay to have these made or take one off your hands that may be collecting dust, of course if the price is right . See links below for reference

http://vintageocd.files.wordpress.com/2012/05/cafe-racer.jpg
http://thvphoto-dv8.blogspot.com/2011/11/grievous-angel.html?m=1
Or
http://garageprojectmotorcycles.tumblr.com/post/11042067267/i-am-yet-to-see-two-sydney-srs-to-be-exactly

 

[cqyqte]

Look for a used NightRod fairing

Comes with headlight as well, pretty simple to mount too.

 

[bdn3d]

That's not to shabby, are they fiberglass? I'm going for the raw metal look...

 

[VonYinzer]

They're ABS plastic I believe, and usually go for a pile of money.

 

[bdn3d]

Yeah not interested in that

 

[ken hosford]

here is a picture of some of my work seat wise alloy not a problem. I could do your bikini fairing if we could figure out a way the get me a damaged plastic one to copy , I could do the fairing in either steel or alloy . If you are wanting to paint steel is better than alloy. If you are not a painter the cost difference to make it in alloy probably be totally covered by not having to pay for paint

 

[bdn3d]

Very cool yeah maybe we can work a deal, getting a plastic fairing maybe difficult though, for reference you can look at http://www.airtech-streamlining.com/vintage/vintagefairingsquarter.htm and scroll down to this one...

CON2
Concept 250 half fairing - competition

Headlight opening: N/A, but easily cut open.

Width front: 13.5"
Width rear: 13" (top) / 15.5" (bottom)
Height: 9"
Length: 14"

The only difference is you would need to cut a hole for a 7 inch headlight.

Also the cheaper the better for me... This is after all only a 360.... And I'm not going to paint them, just going with the raw steel look.

 

[ken hosford]

The con 250 fairing appears to be set up for plexi wind screen ? I did not see listed . Do you intend to run clear plexi screen ?

 

[bdn3d]

Not sure yet, but I can make one myself if I decide to