SQOTD: Best way to clamp down MAC 2-1 header into muffler?

[mattfeet]

Stupid Question Of The Day!

I just put on my new MAC 2-1 and wasn't supplied with clamps. The muffler acts as the 2-1 collector and there is about a 4-5MM gap between the two collectors meaning I cannot fit a standard muffler clamp in there. I tried to use smaller (ratchet clamps) and they dont get tight enough. What do I need to do to make this bad boy tight enough to ride?

It sure looks nice!


Thanks,
Matt

 

[mydlyfkryzis]

Can you get a closer picture of the area? That might help.

Have you tried a T clamp?

E-bay has them, as well as industrial suppliers. Get it in stainless. It gets much tighter than a screw typ clamp.

 

[mydlyfkryzis]

BTW, the bike is looking sharp...!! 8) 8)