Super Clean Mikuni VM30's with stacks, handlers, and a bunch of jets.

[djelliott]

SOLD!









These are a little over a year old. All told I have probably over $400 into this. I'll take $250 plus shipping from my DTT peeps. If they don't go soon they're off to ebay. The jets are 180, 190, and 200 hex mains. They currently have Bleed style emulsion tubes but I also have the primary type. Current needles 6F4 also have 6DHP. Couple of round style mains too and a few selections slow jets (forgot what sizes). The carb handlers are Mikunis with the bolt spacing for a cb/cl 350 or 360. May fit others. The velocity stacks came from 650 Central and are very nice. They are very clean in and out.

 

[djelliott]

These are going to mid ohio with me and will most likely sell. If you're not going and you want them, best make me an offer soon. Just wanted to give DTT first dibs.

 

[schaubster]

Hey djelliott-

Are these the Mikunis from Dime City? The pre-jetted ones?

 

[djelliott]

Close, I bought them from Carb Parts warehouse which is a Mikuni dealer here in Cleveland. I swapped the primary style needle jets they came with for the bleed type. You'll still get the primary style and all the jets I listed with the deal.

 

[djelliott]

Bump.


2 days till mid Ohio. Just keeping these up here for first dibs by the DTT crew.

 

[kevhead75]

Where these set up for a 350? Very tempting.

Kev

 

[djelliott]

Yes. Ran them on mine for awhile.