Looking for some ideas venting a DIY steel gas tank.
I have this track bike that I thought I'd try making a more track oriented tank for. I'm looking for a particular shape toward the rear and top of the tank that is better to brace and anchor my outside leg. They make add on tank pads that do the same thing. I thought maybe I'd make a tank from scratch and possibly save a few pounds too...
here's an example...
https://monkeygripp.com/pro-rider-testimonials/
Well, the tank turned out kinda hideous and not much lighter but I'm gonna finish it and the tank vent is the last thing.
Newton engineering seems to have what I want. I attached their small tank vents pdf below. Thinking of using the thv45.
If anyone has installed a tank vent and has suggestions, I'd like to hear about them before I spend money on this.
I have this track bike that I thought I'd try making a more track oriented tank for. I'm looking for a particular shape toward the rear and top of the tank that is better to brace and anchor my outside leg. They make add on tank pads that do the same thing. I thought maybe I'd make a tank from scratch and possibly save a few pounds too...
here's an example...
https://monkeygripp.com/pro-rider-testimonials/
Well, the tank turned out kinda hideous and not much lighter but I'm gonna finish it and the tank vent is the last thing.
Newton engineering seems to have what I want. I attached their small tank vents pdf below. Thinking of using the thv45.
If anyone has installed a tank vent and has suggestions, I'd like to hear about them before I spend money on this.